|
||||
|
|
|
|
|
Cat5 Crimping Directions |
|||
[Step One] |
Strip off approximately 3/4 inch of the outer sheath of the cable. Be sure not to cut or damage the wires. Un-wind the wire pairs and assemble the pairs of wire in the order shown in the pictures at right. |
  |
|
[Step Two] |
Cut the wires flush, leaving only 3/8 inch of wire extending from the cable sheath. Insert the wires into the RJ45 jack as seen below. Be sure to keep the wires in the correct order. Make sure all the wires are visible from the end of the connector (the left end, in the picture...) |
 |
|
[Step Three] |
Insert the RJ45 connector into the crimping tool (again, carefully making sure the wires stay inserted in the correct order.) Crimp down firmly on the crimping tool to permanently attach the RJ45 to the CAT5 cable. |
 |
|
 |
||
205 SW Second Street Braham, MN 55006 - local/320.396.2990 - toll free/888.383.8837 - email/info@genesiswireless.com |
||
Proudly Serving East Central Minnesota Since 1999! |